Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem slightly old, but it is still appealing. It's not the plushest car in its class It's the Ford Focus or Volkswagen Golf will shield you from imperfections on the road - however, it's a comfortable and comfortable drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. Whether the problem is intermittent or constant, the following tips should help.
Water Damage
If you happen to leave your key fob in a pool or get it wet while kayaking, swimming canoeing, rafting, or canyoning, it's likely to suffer water damage. The best way to stop this from happening is to keep it in a dry bag whenever you're outdoors or performing things where the fob might be exposed to a lot of water.
It's also crucial to make sure the fob has completely dried before you open it and use it again. If you detect any smells emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, it's another indication that it's been submerged in water.
A circuit board that is wet could cause the battery's charge to drop its energy or even explode. If you're able, if you can, pull your key fob 308 out from the body of water it was stuck in it, flip the button side down and shake out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board clean using a cotton swab that has been submerged in 90 percent alcohol.
Other reasons why your Peugeot 308 remote keyless entry system that you use to enter your home may be unable to function could be due to the battery of your coin is dead or receiver module issue, signal interference, or a faulty electronic chip. If none of these causes the issue, try resetting the system by disconnection of the battery that is 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start feature that allows the driver to start the car from afar, warming up or cooling down the vehicle prior to entering. peugeot 207 car key is extremely beneficial, especially during cold winter months. The remote start system can be stopped for a variety of reasons, including the battery being dead.
A coin-shaped battery located inside the key fob has a lifespan of between two and four years, depending on how often it is used and where it's purchased. Its use-by date is typically written on the package or listed in the instruction manual.
If the key fob stops working after exposure to water that is clean and you want to take the battery off, clean the chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If exposed to soapy or salty water, the chip could be damaged and you'll have to replace the key fob in total.
If you're not sure that the battery is not working properly You can test the voltage with a multimeter that is set to the car's voltage range and connected to the minus and plus terminals. If the voltage is lower than 12-13 volts, then you must replace the battery. If you want to, you can try to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first and then negative). The engine should begin to run after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, it's possible that your receiver module has discovered a problem. It's that part that sends an alarm to the car when your key fob is activated, it also acts as an immobiliser. It stops it from starting unless the correct key is in place.
This could be caused by various causes, such as water damage or simply ageing. If the electronic chip inside your Peugeot 308 keyfob has been damaged by dirty tap water it could be due to the fact that the keyfob was exposed to it. In this instance, you'll have to take it off and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue isn't resolved, it's probably a good idea to seek out a local Peugeot specialist or locksmith. They'll be able utilize a diagnostic tool to identify the problem and repair it for you.
The loss of your Peugeot car keys could be an incredibly stressful experience. However, a trained auto locksmith can solve the problem in minutes. They can program your vehicle and cut a brand new, working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip in your Peugeot 308 key fob is a very crucial component of the remote control system. If it is damaged your car might not start or you might receive a message saying "anti-theft active". If this occurs, the only way to fix the issue is to get a new key. Fortunately, auto locksmiths with experience can provide the service in the shortest amount of time.
The chip inside the chip of your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob has been exposed to soapy water, you should clean it immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. After that, you should allow the battery to completely dry.
Sometimes, a key fob can not function due to radio interference. This can be caused when other devices use the same frequency as your Peugeot keyfob. It can also be caused by bad weather or objects in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you encounter this issue.
The Peugeot 207/308 key fob is extremely delicate and requires extra attention. It should not be dropped or throw it around. If you lose something, try to locate it as soon as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Be sure to disconnect the negative first, and then the positive.